Fleck FLECK5600 control mode is divided into: the time (T), flow rate (M), Application: softening (S), filtration (F) water softener models: 5600ST, 5600SM, 5600FT out of the water pipe diameter: DN20, DN25 biggest single valve design Out of water: 1.5M3 / Hr 1. Water softening process automation: US FLECK controller driver via synchronous motor control device to achieve the ion exchange resin regeneration and automate the whole process. Just added periodically regenerated catalyst can be under automatic condition, continuous or intermittent water supply. 2. Efficient: water softener overall design is reasonable, so that the effective work of the exchange capacity of the resin can be fully realized. 3. The water stability: US FLECK controller can accurately control the flow, regeneration time and the various stages of regeneration degree, ensure the water is stable. 4. Provincial workers: no set up special duty, easy to install, install the same day, the day of use. 5. Provincial Water: water softener system rate of 98%. 6. power: the use of renewable siphon principle, without salt pump, power consumption is only about 1% manual water softener equipment. 7. Small footprint: just provide resin tank and salt tank footprint, saving pipeline, salt pump footprint. 8. easy to adjust: the user can according to the actual situation and needs, self-adjusting regeneration cycle and regeneration time. 9. The use of electronic control and have power and memory function, you can check water production during peak hours, with a total cumulative production history of water, can analyze the situation on the water. Low operating costs due to the high degree of automation, water softener can adapt to change, precisely metered water production, accurate measurement of the amount of recycling agent, to avoid wasting innocent regenerant regeneration, and can save a lot of labor costs. 1. The foundation needed near the level of ordinary cement surface can, water softener need to drain or gutter. 2. The raw water hardness: <8mmol / L (ie 400mg / L, such as hardness greater than 8mmol / L, please declare in advance the user). 3. the water pressure: sustained pressure 0.2 ~ 0.6Mpa (including water production work processes and regeneration) (eg <0.2Mpa pipeline pumps to be added); when there is insufficient inflow pressure (or without constant pressure), need to be equipped plus pump, but the need for pumps open and close control. Generally the pump control requires two signals, one is to soften the water tank liquid level signal, a control valve is in progress signal regeneration process. So when a user in case of need for water pumps, please declare in advance, I will make a special delivery. 4. Working temperature: 2 ~ 50 ℃. 5. Power: 220V 50Hz. 6. raw water before entering the water softener, the user should be added to Y-type filters, to avoid blocking impurities in the water body. 7. The pressure gauge should be installed into the water line and install a bypass valve between the pipeline and out. 8. If the user equipment installation, supply other requirements, please specify in the contract.